Boiler stopped or won't start: what you can safely check and when to call straight away in Belgium (2027)
Short answer: Check only what needs no tools: power, thermostat, error code, pressure gauge (Bosch Belgium gives 1.0 to 2.0 bar as ideal; read it ideally with the system cold and follow your manual) and whether the gas or oil valve is open. For a gas smell, smoke, CO symptoms, water from the boiler, repeated lockout or no heating in frost: do not experiment, call immediately. Never open the casing.
Prices in this article are indicative Belgian market ranges, not Alpha Services Benelux's price list. Your fixed price is in the quote.
Boiler stopped: what can I safely check?
Six things can be checked without tools and without opening the boiler. Write down what you see: it saves the technician time on the phone.
- Power: is the display on? If the breaker trips again after being reset, call.
- Thermostat: is it set to heat, above room temperature, with working batteries?
- Error code or light: note the code exactly (for example F.22) or the colour of the light.
- Pressure gauge: read the needle or display, ideally with the system cold.
- Fuel: only look whether the gas tap or oil shut-off valve is open and the tank is not empty. If you smell gas, touch nothing.
- Burner: on an oil boiler, a red light or red button can indicate a lockout; see your appliance manual.
Boiler running but radiators cold? The cause is often on the radiator side rather than the boiler itself. Have a technician check it, see boiler and heating.
Error code and boiler pressure: what do they mean?
An error code points the way; the manual for your model gives the exact meaning. Codes differ by brand (Vaillant ecoTEC, Buderus, De Dietrich, Ferroli, Weishaupt) and model, and an oil boiler works differently from a gas one.
As an example, for Vaillant gas boilers only: F.22 = water pressure too low (or a faulty pressure sensor), F.23 = temperature difference between flow and return too large, F.28 and F.29 = no flame at ignition or flame lost during operation. The same Vaillant page also says: do not open the boiler casing.
For pressure, Bosch Home Comfort Belgium gives 1.0 to 2.0 bar as ideal. Selectra Belgium quotes Bulex documentation (including the Thermomaster manual) with 1 to 1.5 bar, and stresses that this is not a universal standard. The sources differ: follow the value in your boiler's manual and ideally read it with the system cold. Repeated pressure loss is a signal to have a technician look, not to keep correcting it.
Diagnosis table: which symptom, which cause, wait or call?
| Symptom | Possible cause | Wait or call? |
|---|---|---|
| Display off, boiler dead | No power or tripped breaker; can also indicate an internal fault | After checking power: if it stays off, call the same day |
| Low-pressure code (e.g. F.22 on Vaillant) | Water loss or a faulty pressure sensor | Call the same day; if you see water or pressure keeps dropping: call now |
| Ignition-failure code (e.g. F.28 or F.29 on Vaillant) | No flame at ignition or flame lost | Call the same day; gas smell or frost: call now |
| Red light or burner lockout (oil) | May point to a fuel or burner problem | First time: note it and call the same day. If it returns: call now |
| Boiler runs, radiators stay cold | Often on the radiator side | Have the radiator side checked; in frost: call now |
| Boiler cycles on and off, gurgling noise | May point to air in the circuit or a failing part | Call on the next working day |
| Gas smell, smoke, soot or yellow flame | Gas leak or poor combustion (CO risk) | Emergency: call now |
| Water under or coming from the boiler | Leak in the boiler or pipes | Emergency: call now |
Aquastat and automatic air vent: what they do and signs of failure
The aquastat (boiler thermostat) monitors the boiler water temperature; the automatic air vent lets air escape from the circuit. Only a technician works on these parts.
Aquastat. It is not the room thermostat, which only passes on the call for heat. A boiler that keeps firing and gets too hot, or cuts out too early so the home does not warm up, can point to an aquastat problem. Check the room thermostat and power first; do not touch internal controls.
Automatic air vent. Air in the circuit can show up as gurgling or hissing, cold radiators or fluctuating pressure. A vent that lets water drip is a reason to call a professional. For anything on or inside the boiler, Vlaanderen.be recommends a certified technician.
When is a stopped boiler an emergency and who do you call?
A gas smell, smoke, CO symptoms or water from the boiler are emergencies; no heating in frost is urgent.
- Gas smell: follow the Sibelga and Fluxys guidance. Open doors and windows, no switches, no flames or sparks, leave the building and call from outside, either 112 or your network operator's 24/7 emergency line (Sibelga in Brussels, ORES or RESA in Wallonia, Fluvius in Flanders). The number is on their website.
- Carbon monoxide poisoning: headache, fatigue, nausea, dizziness, often in several people at once. Other signs: soot, abnormal condensation, a yellow instead of blue flame. Ventilate, get everyone outside and call 112 for severe symptoms. For advice you can contact the Poison Centre. Source: Vlaanderen.be, gezondheidenwetenschap.be.
- Water under or from the boiler, or smoke: switch the boiler off only if that is safe and dry, and call at once.
- Repeated lockout or fault: do not keep trying, call.
- Frost and no heating: frozen pipes can burst, have them checked via emergency plumber. Vlaanderen.be advises a thermostat of at least 5 °C during long absences to avoid frost.
For an urgent heating, plumbing or electrical emergency, Alpha Services Benelux is reachable 24/7 on 0485 44 55 12. More info: boiler and heating.
Safe checks versus never-do: what to do and not do when a boiler stops
| Safe to check | Never do |
|---|---|
| Whether there is power and the thermostat is set correctly | Open the boiler casing or cover plates |
| Note or photograph the error code and lights | Turn internal controls or the aquastat |
| Read and note the pressure gauge | Top up pressure or reset yourself, again and again |
| See whether the gas tap and oil valve are open | Use switches, matches or a flame when you smell gas |
| Open windows if there is a smell or symptoms | Thaw a frozen pipe or condensate drain with an open flame |
| Switch the boiler off if that is safe | Block the flue or ventilation grilles |
Regular servicing lowers the risk of breakdowns. In Flanders it is mandatory from 20 kW: gas every 2 years, oil every year, by a certified technician (source: Vlaanderen.be). Brussels and Wallonia have their own rules; ask your technician.
What to tell the technician on the phone
Four details are enough to prepare a technician well.
- Symptom: no heating, no hot water, noise, smell or leak.
- Error code: the exact code or the colour of the light.
- Pressure reading: the value you read, and whether the system was cold.
- Since when: date, time and whether it has happened before.
Also give the brand and model (on the rating plate), the fuel (gas or oil), whether it is freezing or pipes are frozen, and whether anyone has symptoms (headache, nausea). A repair depends on the failed part and is quoted after inspection; whether replacement makes sense is something to discuss with your technician, see boiler and heating.
Fixed quote after a site visit
Alpha Services Benelux does the work with its own team, active since 2014. VAT BE 0541.320.178.
Request a quoteFrequently asked questions
What should I check first when my boiler stops working?
Check there is power and the thermostat is set correctly, note the error code and lights, read the pressure and see whether the gas tap or oil valve is open. Never open the boiler. For a gas smell, smoke or CO symptoms, leave the home and call.
What is a normal boiler pressure?
Bosch Belgium gives 1.0 to 2.0 bar as ideal; Selectra quotes Bulex documentation (including the Thermomaster manual) at 1 to 1.5 bar and stresses this is not a universal standard. Follow your manual, ideally read the gauge with the system cold, and have repeated pressure loss checked by a technician.
What does an aquastat do on a boiler?
The aquastat (boiler thermostat) monitors the boiler water temperature and works with the burner. A boiler that overheats, keeps firing or cuts out too early may point to a problem. Checking and replacing it is work for a certified technician.
What is the automatic air vent on a boiler for?
It lets air escape from the heating circuit. Air can show up as gurgling, hissing, cold radiators or fluctuating pressure. If the vent drips water, call a professional rather than working on it yourself.
When is a broken boiler an emergency?
With a gas smell, smoke, soot or yellow flame, CO symptoms (headache and nausea in several people), water coming from the boiler, repeated lockout or no heating in frost. Call 112 or your network operator's gas emergency line, then a technician.
Who do I call for a gas smell in Belgium?
Leave the building first and call from outside, either 112 or your network operator's 24/7 emergency line: Sibelga in Brussels, ORES or RESA in Wallonia, Fluvius in Flanders. The number is on their website. Do not use switches, flames or a phone indoors (source: Sibelga, Fluxys).
Sources
- Smell of gas — Sibelga
- Gas and emergencies — Fluxys
- Let op voor CO-vergiftiging — Vlaanderen.be
- Wat is CO-vergiftiging? — Gezondheid en Wetenschap (Antigifcentrum)
- Verplicht onderhoud van uw cv-installatie — Vlaanderen.be
- Verwarmingstips — Vlaanderen.be
- La pression de l'eau de votre chaudière — Bosch Home Comfort Belgique
- Le manomètre, le cadran qui dit si votre circuit manque d'eau — Selectra Belgique
- Boiler fault codes — Vaillant